ich bin neu im Umgang mit Lancom-Geräten und deren LCOS Bedienung. Ich habe einen neuen LX-6400 Accesspoint, dieser soll an einem Switch hängen, dessen Port als VLAN Trunk konfiguriert ist, dh. alle Pakete werden getaggt übermittelt. Über die Weboberfläche des LX-6400 scheint es nicht möglich zu sein, die VLAN Nummer des Management Interfaces zu konfigurieren, daher bin ich auf die Konsole gewechselt.
Ich habe gefunden, wo ich das VLAN eintragen kann:
Code: Alles auswählen
root@ap:/Setup/IP-Configuration/LAN-Interfaces/
> ls
Interface-Name Interface-ID VLAN-ID IPv4-Address-Source IPv6-Address-Source Static-IPv4-Address Static-IPv6-Address Comment
================-------------------------------------------------------------------------------------------------------------------------------------------
INTRANET br-lan 0 static static 10.0.0.2/16 ::/64
root@ap:/Setup/IP-Configuration/LAN-Interfaces/
> set ?
Possible input for columns in table 'LAN-Interfaces':
[1] Interface-Name : 64 cahrs from INTRANET
[2] Interface-ID : 16 chars from br-lan
[3] VLAN-ID : 4 chars from 0-4095
[...]
root@ap:/Setup/IP-Configuration/LAN-Interfaces/
> set {3} 1001
root@ap:/Setup/IP-Configuration/LAN-Interfaces/
> ls
Interface-Name Interface-ID VLAN-ID IPv4-Address-Source IPv6-Address-Source Static-IPv4-Address Static-IPv6-Address Comment
================-------------------------------------------------------------------------------------------------------------------------------------------
INTRANET br-lan 0 static static 10.0.0.2/16 ::/64
Was mache ich falsch?
Danke und Gruß
JanHH